A tilt pipe Any marijauna pipe will do, as well, just get a screen if the hole in the bowl is too big. Screen size should be smaller for loose trichomes than pressed hash, of course. On top of normal marijuana bowls. In joints. So many ways, so little times. Hell, just eat it
1. well any ol' bottle with a small hole and a cigarette to burn the hash. 2. When i was in europe though, people would just break off small portions and mix it with tobacoo in a joint.
Just stick it in a pipe or mix it with tobacco (or just weed if you have it) as Rafaela said and put it in a joint. You can also make brownies with it or hash oil.
You make brownies with any marijauna. It is not necessary to cook hash to eat it. Nor should you make oil from hash, either.
i've never smoked hash i plan on getting about 2 oz. of stems and gettin homeboy to make me some hash
hash under glass it's awsome all u need in a paper plate a pin or needle a 8-10 oz. glass and some hash push the pin through the bottom of the plate place the ball of hash on the tip of the pin light the hash till it catch's a flame blow out the flame after a few second's cover with the glass let the glass fill with smoke when the glass is full tilt the glass off the plate and inhale it's great
Well, to be honest, I've never tried it, it might be an interesting experiment, but... I don't think that hash, which is already a concentrated form (30-50% THC) would make the best medium for further oil extraction... From the butane honey oil thread at overgrow: I am guessing that perhaps the compressed-nature of the hashish would make it difficult for the butane to "get around" all of it and make a nice extraction, and you would be left with some so-so oil and some bad butane-tainted hash. You would probably get better results with an alcohol extraction (my preference), though chemically speaking, there needs to be SOMETHING for the cannabinoids to go into, and I am not quite sure what the saturation point is... The highest tested hash/oil I have heard about is a bit over 50% THC - there likely is higher somewhere (I'd love a link if you find it)... So there is likely a saturation point in your medium somewhere around there. Thus, you will likely lose/waste a fair amount of hash in the process of converting it to oil for little to no gain. Again, I haven't tried it, so it may very well work just fine - but it is *totally* unnecessary and there is a chance you could end up losing way too much for little-to-no gain. My however-many-cents-it-is-worth-to-you (while doing a cursory search for tested THC percentages of hash oil, I came upon this link which says "pure liquid THC" - but then again, his oil picture is a nasty black so ) (this extraction on erowid says "this method will not approach 100%"... leads me to believe, however, ISO extraction of hash could be useful) (still can't find any tested results of good oil )