Anyone experianced IV'ing Hydrmorph/Dillaudid

Okay so let the judging begin.
I need some help for my first time Injecting Hydromorph-contin.
Looking for anyone who has personally IV'd these.
Now i have searched alot but there are alot of conflicting ways to IV these so im looking for someone who has first hand experience.

Now for those who don't know hydromorph-contin is a canadian version of diluadid. Not as great. They are capsules with small wax beads in them that you break open. I've tried literally every ROA with these with success and the reason why I am heading down this "dark path" is because this will most likely be my last time getting these. I've never had H or been able to find some so I want to try and achieve this "rush" everyone goes on about just once. Now your going to say dont do it cause youll never stop but ive heard that with many other things and have always been able to stop myself.

So if you have experience prepping hydromorph-contin for IV please give me instructions on how you do it to verify if my steps are correct.

Im also wondering some say to heat the solution in the spoon others say not to.
Some say the hydromorph-contin's cant be IV'd because of the wax coated beads but ive read successful reports.
What are the best needles to use?
Is a cotton ball enough to filter or is a micron filter necessary for these?

Ill be going to the needle exchange to procure my supplies. I use the 6mg hydromorph-contin capsules (pink). I average about 6mg a day. So when i do IV i plan to just do 1mg at first.

Anyways thanks for reading. Any help is greatly appreciated.

 

I am 100% not going to judge you, but please hear me out. I was diagnosed with a terminal blood disorder 10 years ago. At first I was on 100mg of OxyContin twice a day. When that became ineffective on its own I needed to be hospitalized for pain management. I was still taking my prescribed OXY but they added 4 mg of Dillaudid (hydromorphone) every two hours (Which is an enormous does). The Doctors assured me that I would not become addicted to it and that the body would only become "dependent" on them. Well please let me tell you first hand that they were full of shit. I like so many others went into it thinking I'd never be addicted...not me. Because of my blood issue I am in the hospital very frequently receiving BOTH my OXY and IV. Dillaudid in mass quantities. This is not a drug you can escape from. I promise you that you will become addicted, maybe not at first, but I promise you with 10 years of experience I'm rights.

I too have never used H but you do realize that all D is comprised of is synthetic H.

I know that I don't know you, but I also know that I've been in your shoes. AND THIS WILL KILL YOU. It's alctually used now in some states at part of lethal injection. This drugs will make your blood pressure drop to the floor and cam cause you to stop breathing.

LIKE I said before I am in no way judging you at all because I've been there. BUT please please please think this through you shoot it.

Again Please just think about it. Also I'm not one that preaches don't do drugs, but you don't know what your getting into with this one. If you are deff going to take them swallow them slowly.

 

Alright this is all opinion based and some very well may disagree with me but it all depends on what kind of D's you are getting.Some are harder to bang then others,some need heat to dissolve & others don't.The best D's for slamming were the ones made by abbott pharmaceuticals they have the a on one side and the # of the strength on the other. D's made by other places like purdue,Knoll I never got but I heard they are harder to slam then those made by abbott ?

This was just me now like I said above some may prep their shot different but the way I would go out slamming mine were I would crush the pill first add the power to the spoon or cooker,put my water usually 30 or 50mgs depending how many pills MG's I was doing.mix it up thoroughly then add some heat until right before it boils, stir it again put in my cotton and then draw that bad boy up into my rig !

Thats what worked for me other D's like I said my be harder or easier so good luck

 

I use to IV D's and M's its a awesome high man. I did it for years and I tried to get off and I couldn't. So now I am on methadone treatment I have to take 125mg of Methadone everyday now. If its your first time find some good friends, have a great environment because that first time only comes 1 time. Enjoy.

 

These are just safety tips, they aren't necessarily in order.

1. Make sure your product is crushed up finely using clean hands/instruments
2. Only use sterilized water. Tap water can burn your veins with chlorine and a water dispenser could have bacteria trapped in it.
3. The more water the better, your product will soak up some of the liquid so you may need 2 needle's worth of water in order to fill one needle
4. Mix your product with either cold or warm water. I personally don't recommend cooking any type of pill whatsoever in case some of the fillers dissolve into the water along with your drugs.
5. Use a micro/dental filter. These are made of compact cotton or other material designed specifically for the purpose of filtration. Cotton balls, cue tips etc. allow fillers to get through and therefore end up in your veins/heart valves so I don't recommend those.
6. If you have fresh veins, you don't need a bigger gauge than 28-29 or so (1mL). Doesn't have to have a very long tip, just enough for it to fit snug in there.
7. For your first time IVing, you may want to have a solid idea of how much hydro gets you high in the other ways you do it and what your tolerance is like. This will help you determine how much to put in a shot. You could go with your usual dose, but make sure it is administered slowly if you didn't reduce it. If you fuck this up you could risk getting violently ill or worse.
8. Make sure your veins are clearly visible and popped out with a tourniquet. Sometimes they will try and "hide" from the needle which is natural, so the tourney helps a lot with that. Always use your arm veins and don't use any above your elbows. Make sure it is a vein and not an artery. Arteries will have more a of a "pulse" and are easily spotted out. Use alcohol swabs or wash your arm in the place you intend to inject.
9. If blood draws back into the needle, you know you're in.
10. Once you're in, remove tourney. Test to confirm by drawing a little more blood. Now is time to take the plunge...
11. If for whatever reason it comes out of place or you feel more pain than the initial prick when plunging, stop and remove it! Some people are impatient and will shoot it in anyways. Never do this. If it feels like it isn't "flowing" into you properly, there's something wrong. Readjust the needle and try again, getting nasty bubbles/infections in your arm isn't worth it.
12. Don't reuse needles, period!
13. Some re-use the product and "wash" it again to get an other shot. This is a personal choice, however, I'd advise against it since more fillers are bound to find their way into your hit this way.
14. Everybody is right. This isn't a casual drug like pot or cocaine even. It's all or nothing and it doesn't seem that way until it's too late. I'm not saying don't do what you're gonna do, but what I am saying is it looses it magic real fast (sometimes after the first time the dragon cannot be caught again, EVER).

P.S. What kind of prices are you paying around here? I'm a little curious. Sometimes I can score $1 a milligram, other times it's brutal like $20 for 12mg.