Relieving the pain

Discussion in 'Synthetic Drugs' started by otb01, Jun 19, 2007.

  1. otb01

    otb01 Member

    Messages:
    522
    Likes Received:
    0
    Since so many synthetic drugs burn when snorted, would a little bit of lidocaine powder numb out the burning? I recently found an ampoule of it which I estimate is from the pre-80s that has been stored in the dark in a cool-ish enviornment.
     
  2. mask_of_insanity

    mask_of_insanity Member

    Messages:
    180
    Likes Received:
    0
    where the fuck you find that
     
  3. otb01

    otb01 Member

    Messages:
    522
    Likes Received:
    0
    Is that the point of this topic? I didn't think so.
     
  4. IcarusRisen

    IcarusRisen Member

    Messages:
    120
    Likes Received:
    0
    Well it probably would help numb the burning. But frankly, if what you're using is over 2 decades old, I'd be concerned it wouldn't work regardless of where it was stored. But, no harm in trying I suppose.
     
  5. otb01

    otb01 Member

    Messages:
    522
    Likes Received:
    0
    Ok sounds good by me. I will tell when things are said and done.
     
  6. framesh1ft

    framesh1ft Member

    Messages:
    335
    Likes Received:
    0
    It works better in solution. If blended in with a powder the sting will typically hit first then the numbing from the lidocaine. I'd also be a little concern about the drip and lidocaine mediated swelling and breathing issues. I doubt it would be a problem for most people at a low percent of lidocaine, but just a word to the wise.
     
  7. fryingsquirrel

    fryingsquirrel Member

    Messages:
    673
    Likes Received:
    0
    I've snorted coke to numb my nose in preparation for other drugs, worked great. Don't see why any "caine" wouldn't work.
     
  8. otb01

    otb01 Member

    Messages:
    522
    Likes Received:
    0
    Hm, thats true about the possible respritory depression... I could try a tiny bit as a pre-run test to be sure.
     
  9. framesh1ft

    framesh1ft Member

    Messages:
    335
    Likes Received:
    0
    The trick is to get the particle sizes of the powder, i'll call it powder A, and lidocaine about the same. Then figure on 0.1 to 4% lidocaine.hcl
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice