Advice needed!

SWIM used the isopropyl alcohol method, but let the material soak too long before straining it out. The product is dark dark green, almost black, and incredibly sticky/tar like. Will it eventually dry out into something workable? Will heat or pressure aid the process? Thanks!

 

wtf is this forum...puppets and puppeters?

 

In my experience alcohol makes oilier, stickier,inferior prod. (it'll get ya' hi, but also may cause headache from the other stuff in it) I've tried heat (degraded potency) and leaving to evap. for a month made no diff.

 

man what the hell is happening here. its crazy

 

Thanks for the tips. SWIM tried to scrape a bit onto a pin and smoke it 'under glass,' and it melted nearly instantly, making it about impossible to use. SWIM will try some heat. What about adding some ground plant matter to improve consistency?

 

you can add kif if you want. But something black is just not worth the trouble. But was it solid. The more it vaporizes quick the better it is. ( ismoke it in the bong though)

dont try heat. Try using better plant matter or shaking for a shorter time (ad this short shake is the only thing making this method unlike all the other iso oil methods, get it? The key). And drying the right way, on the boiler then a fan. If you consider all the variables, and have something a bit better than brick shwag you cannot get something that is still sticky. (last variable, too much of a thick layer of oil on your plate, i doubt it though)

I mean its not hard. As it evapes the level of liquid in the plate goes down and down...until there are just little spots where you see water. Then the rest is pretty quick, until you can turn the plate upside down and no liquid falls at all. Then you put it under a fan you can find. Moisture left has much time to do so in an hour or 2. And using 3 grams or something similar, the layer of oil is so thin that it just cant be sticky unless you messed it up in makin the solution and straining. Even if it had the quality of pipe resin!

'People wanna get you high, high in the sky, but you're always a step ahead of the ground...Watch out for piranhas!'

 

Oil Under Glass...on a pin.......HMMMMM! Just add heat and watch it run down the pin and away from your lungs. Best way I've found so far is to scoop it up w/knife blade or equivilent there of, point the oily end down at your pipe bowl stocked w/burnage (pot, tobac. etc.) add a little heat to blade above oil just enough to make it drip into bowl, turn the flame on th' bowl inhale enjoy, some I hear like to use same method on the end of cigars or cigarettes for that stealth high!

 

^^

yea I like doin BT's

water bottle, oil + pin, cigarette = A great Headrush..

 

wthell people call this bt too here does something stand for bt?...

edit....oh ok! bottle tokes!

jah my girlfriend always smokes her hash like that, pickin up little beads with her cig. But you need good one for it or burns really slow and the toke fuckin kills you throat. i prefer the bong though, as you can take like 5 bt's in one.

 

next time insead of alcohol use actone it evaporates completly and leaves no taste behind BUT USE CAUTION IT ISNT SAFE TO BREATH AND IS VERY VERY FLAMABLE use outside if you can and you can put it in a slow cooker on low (outside) to evaporate it alittle faster but it can just be left out on its own and that will work just fine. one last note not nail polish remover its deluted acetone can be found at most hardware stores

 

Way to rezz a year-dead-thread.

Update on SWIM's situation: he went BHO and has never been happier.

 

Ahhhhh... I love a happy ending!