TEK - Injecting MS Contin 100mg Generic (Novo-Teva)

Like the topic says this is a step by step guide to inject MS Contin 100mg Generic versions and specifically MS Contin 100mg Novo-Teva (Canadian Generics)

Canadian MS Contins:
Purdue Pharma
Novo

USA MS Contins:
ABG
Watson
Mallinkrondt
More

The reason i'm posting this is to provide a safe way to inject morphine and to say yes it is possible and yes this is the best return. This is a method meant to beat the GELLING of morphine pills when water is added and to provide a clear solution to inject.


MSContin 100mg NOVO
http://t0.gstatic.com/images?q=tbn:ANd9GcQNu9ERVQyVWOinDadxIT8mOlUaONWyXuP1WF3Bpj8CEYWwlf-5&t=1

Materials:
Lighter
Big spoon
MSContin 100mg
Debitcard/razor
Filter (Either little piece of a clean ciggarette filter or the end of a qtip balled up = Make SURE its a nice filter)
Glass of Water with a spoon of salt in it and ice cold. Mix up the salt and make sure its dissolved
Syringe (I Use BD Ultrafine II 1CC Short Tip)

1) Suck off Coating, make sure pills white and dry.
2) Crush it up with a debit card or whatever and then chop it into as fine
as powder as possible. Use a hose clamp to shave if it you have
3) Scrape the powder into the big spoon and make sure its not in a big lump but evenly spread out in a thin layer like a debit card thin or maybe a bit more but u know what i mean.
4) After the water is dissolved with the salt and its cold take your syringe and suck up a full barrel so 1cc 100 units and set it aside for when you need to spray it in the spoon, also with another syringe suck up 30ccs of the water and set aside as well you will spray this as well. Also get your filter ready and have it beside the syringe.
4) Take the lighter and light it under the spoon evenly around so you are cooking all the powder. This usually takes 1 Minute maybe bit more but make sure you do not do it to long or your liquid will come up black and u know youve over cooked it. So keep cooking the powder until a little wiff of smoke puffs off the top then you know its ready. The powder may look a bit brown and thats good, just DONT bake it for to long.
5) Now the spoon will be really hot and if you spray teh water in right away it will sizzle and spit, you can do this but i find its better just to let the spoon sit for 20 seconds and then spray the whole full 1cc 100 units of salt water into the spoon.
6) Take your lighter and heat under the spoon for about 6 seconds just to get the water to an almost boil and lay it down. Spray the other 30 ccs of cold water into the spoon and do a quick little mix. It should be a consistant water based almost yellowish colour.
7) Drop the cotton in and it will immediately blow up, law your needle gently on the cotton and start sucking up the liquid slowly.
8) Now you'll notice you only get back about 70-90 cc's of water when you spray in 120cc but thats the thing with morphien you won't get back all of it. That is also considered a very high yield. After you suck it all up you will notice a glob of goo around the filter and the filter will be rock hard (this means you did it well) so take out the filter and throw it out but leave the syringe with the goo and there will still be some powder in there thats able to have a wash after
9) Save the spoon so after you can spray in some water and mix it up and suck up whatever is left in there


10) Now take your syringe with what should be a yellowish liquid and pop in ur vien, pull back on the syringe to get the red flag (lil bit of blood) and shoot away. It will take about 6 seconds to hit and first your get a rush and then you get these pins and needles which is sometimes uncomfortable for some people but it passes.
And there you go