Making LSD

I just have found this and want to ask some questions.

MANUFACTURE OF LSD

Materials:

1. Ergotamine tartrate

2. Hydrazine hydrate

3. Hydrazide

4. Hydrochloric Acid

5. Sodium Nitrite

6. Sodium Bicarbonate

7. Diethylamine

8. Ether

9. Flasks

10. Filter paper

11. Heating mantle

12. 2 liter three-necked round bottom flask

Time: Approximately 36 hours.

Process:

STEP 1: In a 2 liter three-necked round bottom flask
add to 2 grams of ergotamine tartrate about 1/2 gram
of hydrazine hydrate. Exercise caution when adding
the hydrazine hydrate because it is very poisonous,
particularly to the eyes.

STEP 2: Place a condensing column on one neck of the
flask. Place a stirring device in the center neck and
place a separatory funnel in the thick neck. (Note:
hydrazide hydrate may be added through a separatory
funnel although it is not necessary.)

STEP 3: Place the flask on a heating mantle and simmer
the solution for 2-3 hours while stirring occasionally.

STEP 4: Remove condensing column from flask and continue
to cook for 10-15 minutes or until the original solution
is reduced by half.

STEP 5: After solution has cooled, pour the solution
through filter paper and collect the crystals that
formed. Wash the crystals in a small amount of
absolute alcohol.



STEP 6: Dissolve the crystals in about 30cc of diluted
hydrochloric acid. (Note: diluted hydrochloric acid is
mixed at a rate of 1 part acid to 10 or 15 parts water.)

STEP 7: To the hydrochloric acid solution add about
15cc of a solution of sodium nitrite diluted in water.
(Note: one part sodium nitrite to 10 or 15 parts
water.) Let this solution stand for about 30 minutes.

STEP 8: To this solution add about one teaspoonful of
sodium bicarbonate (baking soda) to make the solution
basic.

STEP 9: Place this solution in a separatory funnel and
add to it an equal quantity of ether. Shake this
solution gently for about 5 minutes.

STEP 10: Separate the ether solution from the
separatory funnel and keep the ether solution. The
remainder may be discarded.

STEP 11: Cool the ether solution to 0 degrees Celsius
and to the solution add a solution of about .5 gram
of diethylamine mixed with ether.

STEP 12: Maintain the solution at 0 degrees Celsius for
24 hours, stirring it occasionally (perhaps 4 hour
intervals.)

STEP 13: Remove the solution from the ice bath and
allow it to stand at room temperature for about 2
hours, or until it evaporates. The remaining crystals
will be crude LSD.



Now i'm not going to attempt it, but if you read some books on chem or even had a chem set, still by no means you should attempt such unless you took a college course correct?, and is it dangerous to attempt? Is it the ingrediants?, and why is dmt considered not as hard to create?

If there is any thing i did wrong with this thread just let me know

 

....just look at a dmt extraction tek and compare the steps. a simpleton can comprehend the steps involved in a DMT extraction, there's just less to do/easier stuff to do. without the need for some very hard to get shit. you can get whatever you want to extract DMT at lowes/walmart

 

I want to know the results of this honestly. just for the sake of curiosity.

it seems like you could end up poisoning yourself if you fucked up. and I have a sneaking suspicion you don't understand the organic chemistry involved sufficient to know what you are actually doing (I don't either) but some of that stuff... well, I know it could turn out bad.


that being said.

good luck, I REALLY hope you succeed, and develop a successful system of doing this as often\much as you need\want.

 

Good luck getting the ergotamine tartrate, it's a controlled substance just like LSD.
Plus that sounds WAY oversimplified.

 

and where did you acquire that recipe?

 

I could be mistaken but I believe most (if not all) of this needs to be done in an inert gas chamber under specific light conditions.

http://www.erowid.org/library/books_online/tihkal/tihkal26.shtml

 

minor glitch huh?

 

the same chems that you need to make LSD, also can make nerve gas. So you really got to know the right people in a post 9/11 world.

Also it's gonna take more then 36 hours

 

I knew I should've majored in Chemistry. Dang it.

 

or law enforcement. They got the most lsd.

 

oink oink look ma im tripping

 

I think the ergotamine tartrate has to be stolen from somewhere. You can't acquire it legitimately.

 

STEP 9: Place this solution in a separatory funnel and
add to it an equal quantity of ether. Shake this
solution gently for about 5 minutes.

STEP 10: Separate the ether solution from the
separatory funnel and keep the ether solution. The
remainder may be discarded.

STEP 11: Cool the ether solution to 0 degrees Celsius
and to the solution add a solution of about .5 gram
of diethylamine mixed with ether.

 

This is the only part that seems un-reasonably dangerous.

Ether is extraordinarily flammable. Having even a small heat source too close to the fumes of ether can cause a terrible fiery explosion.

 

WOWOWOOWOWOWOW

that seems easy.

i always heard that making lucy was super complicated and could only be preformed by a really good chemist. now i'm no hoffman, and i don't have much experience in the lab, but i think i could pull this off...the question is, would the end result be LSD? Seems too simple.

could anyone else post a different syth?

 

The original post is like a paraphrase of the synth. Its pointless.
There is a 'real' synth on erowid.

 

Yep. Read it. So many steps makes it seem like I'd be real easy for a noob to screw up. But I think if one were intent on making, it's definitely doable, and that's why we have LSD today!

 

twang your signature is da kine man! So awesome!
"What are all these bits of paper in my beer?" hahaha

 

No there is legit uses for that. Migrane meds,

and also things related to plumbling like what you would use to prevent corrosion in the pipes I think.

 

why dont you just use the foster's beer recipe