resin question

Discussion in 'Cannabis and Marijuana' started by Fractual_, Jun 3, 2004.

  1. Fractual_

    Fractual_ cosmos factory

    Messages:
    6,927
    Likes Received:
    1
    one day i was taking resin hits off of my bubbler, and a huge chunk of resin fell through to the chamber, and i didnt pay it any mind... and a week or so later i was takin resin hits again and another fell through and they have came together and grown and i have no clue how to get them out of there! any suggestions?
     
  2. wenis

    wenis Member

    Messages:
    74
    Likes Received:
    0
    i don't know how big your bubbler is, but pipe cleaners for tobacky pipes work well. otherwise those kabob stick things maybe, or a paper clip?
     
  3. Fractual_

    Fractual_ cosmos factory

    Messages:
    6,927
    Likes Received:
    1
    you can see my bubbler at the thread "gerbils n things" over in hip photos if you want.

    would the cleaner break up the resin ball though? so it could fit through one of the holes?
     
  4. PeRrY

    PeRrY Member

    Messages:
    250
    Likes Received:
    0
    Just get a paper clip, knock that little guy outta there and smoke him up!
     
  5. Alexandria

    Alexandria Member

    Messages:
    407
    Likes Received:
    0
    if the ball is too big to fit through the carb then just heat it up with a lighter and untill it is soft enough to stick to a paperclip (or whater you use) and then pull it on out!
     

Share This Page


  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice