Just a quick question about a lightbulb vape. I read that you make two holes in the cap. One is for the straw, but what is the other one for? Thanks. Edit: nevermind just found the answer.
well what i did was: 1. used a can opener to pull the metal part of the bulb off 2. underneath there was some clay-ish stuff which i scratched off with a knife 3. i then used a pencil to punch out the filament holder inside the bulb 4. i pulled the leftover bits out of the bulb which gave me just a simple glass sphere with a large hole in the top 5. i then got a bottle cap (quite a big one) and drilled two, straw-sized holes in it (in truth only one hole has to be straw-sized, the other one can be as large or small as you like depending on how quick you want your hits to be) 6. i put the bottle cap on top of the hole in the bulb and used bath sealent (glue or tape would work as well. sometimes if the bottle cap fits perfectly you don't need to glue it on) 7. i then put a straw through one of the holes so that it went about a third of the way down the bulb and glued it in place 8. finally, i made a little stand for it out of some paperclips which held it up over a candle TO USE 1. grind up your weed and put it through the hole in the top (you don't need to use much to fill a lightbulb with vapour) 2. cover or block the hole in the top 3. heat the weed through the glass using a lighter or a candle (if you didnt make a stand like i did i'd reccomend wearing gloves) 4. once you see a mist developing shake the bulb slightly and the mist will develop into a thick fog within the bulb 5. remove the bulb from the flame and allow to cool (if you take a hit straight after heating it burns your throat like f**k) 6. uncover the hole in the top and take your hit through the straw 7. more weed can then be put through the hole in the top and this can be repeated
Your gonna get tiny ash chunks in your lungs if you dont put a filter on the straw. I put on a little screen and it stops so much crap that it has to be cleaned once a sesh.
