I'm currently doing a cold-water extraction on some oxycocet (10/325). Right now it's chilling in the freezer (the freezer is actually not that cold) so I have to wait a while. I'm going to then filter it through a 100%cotton dishtowel, then through a coffee filter that has been soaked in cold water. I will take the goop from the towel and the coffee filter and put it back in some hot water and then back into the fridge, in order to get all the oxy out of it that I can. I need to transport it home, so I'm going to probably put it into a small bottle or something, then evaporate it at home. I didn't measure it out by dosage, so since I used 8 pills (roughly 80mg of oxy) I will just cut up the resulting powder in half by eye and hope that all goes well.
Yikes, I wouldnt want to waste the oxy you're gonna lose in the extraction like that. 8 pills = 2600mg acet. = not enough to do any serious harm unless you do it often. I took 7 T3's straight up once with no ill effects.
Blimey this extraction sounds like hard work? I will look for a thread where it explains it a bit more so i can understand it and how its done.
It's really not. Measure out some warm water, about 2ml per pill (I use a bit more). Chuck the pills in, they should dissolve in 5 minutes or so. Stir. Chill it in the freezer for 15 minutes or so. Stir again and let it settle for a few minutes. Filter it with whatever, drink the solution. Whole thing takes me about half hour max, from measuring the water to drinking it.
The point is to get rid of the acetaminophen so you don't die a horrible painful death due to liver failure.
