makin lsd?

well ive read a technique of makin it by - orange juice, bread, and yeast.

and i would like to know your opinions and experiences of making lsd or ergot.

 

hahaha.

none of us have experience making lsd.

i don't want to sound pessimistic, but you will never make lsd.

 

idk i read this -

and i was wondering.... cause if its real?? ?

 

considering how dangerous it sounds...and how illiterate the poster is...i wouldn't even try it

 

what do u need to worry about?

 

The Culture and Extraction of Ergot Alkaloids
Sucrose .................................... 100 g
Chick pea meal .............................. 50 g
Calcium nitrate .............................. 1 g
Monopotassium phosphate ...................... 250 mg
Magnesium sulphate ........................... 250 mg
Potassium chloride ........................... 125 mg
Ferrous sulphate heptahydrate ................ 8.34 mg
Zinc sulphate heptahydrate ................... 3.44 mg
Make up a culture medium by combining the following ingredients in about 500 milliliters of distilled water in a 2 liter, small-neck flask:
Add water to make up one liter, adjust pH 4 with ammonia solution and citric acid. Sterile by autoclaving.
Inoculate the sterilized medium with Claviceps purpurea under sterile conditions, stopper with sterilized cotton and incubate for two weeks periodically testing and maintaining pH 4. After two weeks a surface culture will be seen on the medium. Large-scale production of the fungus can now begin.
Obtain several ordinary 1 gallon jugs. Place a two-hole stopper in the necks of the jugs. Fit a short (6 inch) glass tube in one hole, leaving 2 inches above the stopper. Fit a short rubber tube to this. Fill a small (500 milliliter) Erlenmeyer flask with a dilute solution of sodium hypochlorite, and extend a glass tube from the rubber tube so the end is immersed in the hypochlorite. Fit a long, glass tube in the other stopper hole. It must reach near the bottom of the jug and have about two inches showing above the stopper. Attach a rubber tube to the glass tube as short or as long as desired, and fit a short glass tube to the end of the rubber tube. Fill a large, glass tube (1 inch x 6 inches) with sterile cotton and fit 1-hole stoppers in the ends. Fit the small, glass tube in end of the rubber tube into 1 stopper of the large tube. Fit another small glass tube in the other stopper. A rubber tube is connected to this and attached to a small air pump obtained from a tropical fish supply store. You now have a set-up for pumping air from the pump, through the cotton filter, down the long glass tube in the jug, through the solution to the air space in the top of the jug, through the short glass tube, down to the bottom of the Erlenmeyer flask and up through the sodium hypochlorite solution into the atmosphere. With this aeration equipment you can assure a supply of clean air to the Claviceps purpurea fungus while maintaining a sterile atmosphere inside the solution.
Dismantle the aerators. Place all the glass tubes, rubber tubes, stoppers and cotton in a paper bag, seal tight with wire staples and sterilize in an autoclave.
Fill the 1-gallon jugs 2/3 to 3/4 full with the culture medium and autoclave.
While these things are being sterilized, homogenize in a blender the culture already obtained and use it to inoculate the media in the gallon jugs. The blender must be sterile. Everything must be sterile.
Assemble the aerators. Start the pumps. A slow bubbling in each jug will provide enough oxygen to the cultures. A single pump can, of course, be connected to several filters.
Let everything sit a room temperature (25 C) in a fairly dark place (never expose ergot alkaloids to bright light - they decompose) for a period of ten days.
After ten days adjust the culture to 1% ethanol using 95% ethanol under sterile conditions. Maintain growth for another two weeks.
After total of 24 days growth period the culture should be considered mature. Make the culture acidic with tartaric acid and homogenize in a blender for one hour.
Adjust to pH 9 with ammonium hydroxide and extract with benzene or chloroform/iso-butanol mixture.
Extract again with alcoholic tartaric acid and evaporate in a vacuum to dryness. The dry material in the salt (i.e., the tartaric acid salt, the tartrate) of the ergot alkaloids, and is stored in this form because the free basic material is too unstable and decomposes readily in the presence of light, heat, moisture and air.
To recover the free base for extraction of the amide of synthesis to LSD, make the tartrate basic with ammonia to pH 9, extract with chloroform and evaporate in vacuo.
If no source of pure Claviceps purpurea fungus can be found, it may be necessary to make a field trip to obtain the ergot growths from rye or other cereal grasses. Rye grass is by far the best choice. The ergot will appear as a blackish growth on the tops of the rye where the seeds are and are referred to as "heads of ergot." From these heads of ergot sprout the Claviceps purpurea fungi. They have long steams with bulbous heads when seen under a strong glass or microscope. It is these that must be removed from the ergot, free from contamination, and used to inoculate the culture media. The need for absolute sterility cannot be overstressed. Consult any elementary text on bacteriology for the correct equipment and procedures. Avoid prolonged contact with ergot compounds, as they are poisonous and can be fatal.

 

i just mean it sounds very risky to eat mold you know nothing about except that someone says it's similar to lsd. there's easier and less dangerous ways to obtain things similar to lsd..like lsa.

 

what about combining LSA.. and Ergot compounds together.. This would take like a very long time... wonder if its possable...??
Creating ergot alone takes a season.. and molding it into a usefull compound takes a while, many hours for a single person to do alone.
Its almost impossible to do it alone and rest enough to keep accurate records.
Not a easy overnight method like Meth...
synth materials for lsd takes easy a day or longer... any other way would take weeks that no lay man has the tools for..
Like building a house without wood.. It can be done with bricks but its still not the same.. Will not have the interior and integrity that a house should have..
So making a compound with the above might work.. Just will not be a Mansion...
but a shack down by the river.. youll have to use your imagination to see naked ladies running around.. Or overdose on the shit to see bright lights a glow.. which will be the lights on the ambulance..

Learn some mycology and save yourself the headaches of Lsd synth.

 

its not.

unless you have a degree in organic chemistry, have access to scheduled chemicals, and have a full lab set up, then its not gonna happen even when you have the real "recipe".

 

There you have it. Good luck .

 

Any other uban cemistry anarcists cookbook bullshit is a lie.

 

This mold idea can work

during the middle ages people ate molded bread and they thought they had gone insane, because it can create LSD like effects, they had no idea why, they thought it was demons.

but it could also get you sicker then shit

 

yeah, I'm pretty sure your thinking of St. Anthony's Fire. Whole town had infected bread, went "crazy" and died shortly after. Please correct me as i'm not 100% sure on all of that.

 

LSD-25 was created by a senior chemist working for an important, well funded company (hoffman and sandoz). It involved many complex, and highly dangerous reactions. furthermore, despite all his safety precautions (ergot derivitives are VERY dangerous), he still came into contact and experienced the first "trip".

in other words, using cheap materials in a kitchen sink is not going to produce this chemical. a high-level chemistry/biochemistry degree is esential.

 

cultivation of ergot takes a long time..

 

holy fuck!
i know that the bread can produce some deadly chemicals.
it was probably a board kid that thought that he can make a fool out of us...

 

Haha, real LSD, d-LSD-25, is one of the hardest recreational drugs to create. Even with a precursor like LSA.

 

get a degree in organic chemistry.
get a lab
get chemicals.
get rich

and dont say you can not get access to ergot. Because you can obviously or else the world would be without lsd.

you just need to know the right people. or grow your backyard full of rye and hope that it gets the fungus. ha

 

yeap.. but it takes a while with mouths kept shut..

 

wow! i think im gonna be an organic scientist! for real! im gonna start studyin and ill make an lsd access for free lsd ! :hat: