how to make a pipe from house hold materials

so does anyone know how i can make a pipe not a super cool one but one that will last a decent amount of time and wont be toxic when heated


thanx



P.s. (and filters)

 

Make an apple into a pipe, just make a bowl on the top with a mouth piece on one side, use tinfoil around the bowl.

Or get a 2 liter and burn a small hole on the bottom side of it, then make a tinfoil bowl for that, make another small hole for a carb, then suck it through the part you drink threw.

Tinfoil is semi-grose, but in you situation, getting high, is getting high.

 

search button

 

thanks for that those are for short notice but i need one that will last awile and after readin about the apple one i went and smoked so now im high

 

I would suggest you invest in some glass in that case.

 

i would but i cant go into a smoke shop to buy one and i hate papers and i dont know any1 over 18 outside of family

 

Most smoke shops will sell to people underage as long as you know what your looking for.


remember to always refer to a "bong" as a "water pipe"


I've bought most of my glass myself, and I'm only 17.

 

I have bought all of my pipes, excluding my bong, at one shop in my town. I bought my first piece there when I was 15. It is way the fuck on the other side of town though so I sadly can't just walk there all the time.

EDIT: Or you could always get a less expensive metal pipe, which will easily service you better than any pop can or ghetto gatorade bong.

 

Do you know what a pale or chute is?

 

a plastic bottle or a soda can. both of those took me a long way before i got my first pipe. a bottle ended up being my prefered pipe and to this day i still say they work good.

towards the top of the bottle, use a lighter and burn a hole in each side. one is for inhaling through, the other is the carb. then take off the little plastic thing thats around the bottom of the cap, place a small sheet of foil in the top of the bottle and adjust it to the size of bowl you want, then replace the plastic thing to hold it on place. finally, use a pin to poke lots of holes in the bowl.

if you want to get fancy, take the paper off the side of the bottle and use a lighter to melt into the side and you can do little designs and shit haha. a fun activity when your blazed.

 

my suggestion is to just use alfoil. wrap alfoil around a bottle top. take it off the bottle, and put a knife or something in it instead, then close the alfoil around the knife and make the mouthpiece neat. poke some holes and shape the bowl at the flat end which gained its shape from the top of the bottle. Then remove the knife.

its not that bad for you, relatively

 

buy online, get a money order and buy online

 

what the hell is with all the ignoring of the OP? he asked about household materials

 

Its been years since I MacGyvered myself a bong but I always liked Dasani bottles. Cap off, foil over the top, burn a small hole for a straw and seal it with some gum if needed. Really simple and effective.

In regards to the aluminum foil, you can burn off the Alzheimer's causing stuff on with your Bic.

 

Hamster water dispenser bottles, soap bottles (some of them have great shapes), well.. any bottle around the house will do... just use your imagination. Try to stay away from aluminum, but if you must.. go ahead, it probably won't kill you.

 

Coke can.

 

The first improvised pipe I learned how to make was from a sheet of aluminum foil. Take a sheet off the roll about as wide as a pencil. Then fold it in half and then use the pencil to roll it up. The tube should be as almost as long as the pencil. Tape the loose flap down, but not near the area where you will be burning the weed, use the rough side. Pull out the pencil leaving a tube. Using the rounded end of the tube (the part that was folded), put the pencil back in, eraser first up to the past the metal part to the wood then fold it in the shape of a pipe. Then take the stem part and loosely flaten it out but not so much that there is no air flow. I often use a paperclip to make a hole down the length of the stem, then pull it out for air flow. I also sometimes rip off the extra tinfoil on the mouth end. I had to try this a couple of times before I had a pipe that I liked. Fill the bowl, light and go to town. I used this kind for a while before I got my first bowl. Have fun and happy hunting.

 

Also, I have another suggestion. Home Depot. Go and buy some copper pipe fittings or brass with screw in fittings. Most of your pipes today are made from some of these items. I bet if you spent some time in the plumbing department and were smart enough about it you could come up with a really cool home made job. Just keep in mind you could go simple or go complex. I would start simple. I would also not do anything that requires you to fix the pipes together with glue or anything with chemicals. Just screw in pipe fittings.

 

Or just buy some papers, maaaan.

 

apple pipes dont need foil to work. smoke clean!