so I have smoked a shit load of dmt in my days, but have only blasted 2-3 times. Ive smoked it in so many ways. freebasing off foil, topping off a bong, making a pipe, etc etc. I was wondering if anyone had a method that enabled them to blast off every time. the smoke is so nasty I have a hard time taking big rips and holding them. Just wondering because I got to smoke some today for the first time in months, smoked a good amount and only got about halfway there. kind of a bummer
The way I'm gonna do it the next time I get DMT is sandwiched in between a bunch of screens in a bong.
If the smoke is very nasty, you are probably burning it. Put it on a bunch of screens and/or a thin layer of weed. Turn the bowl at an angle, so that the liquid will not go straight down the hole. Hold the lighter as far away as possible where the crystal turns to liquid. Take long steady draws so the heat from the lighter goes over the crystals and vaporizes them slowly. It really shouldn't taste that bad if it's being vaporized.
Make The Machine The only materials needed to fashion The Machine are a small glass bottle and a bit of extremely coarse steel wool, as is used for scrubbing pans. For the bottle, a single-serving Hennessy Cognac bottle works great, due to its long neck coupled with a handy pre-formed weak spot in the bottom. After breaking or drilling a small hole in the bottom of the bottle, a bit of steel wool is rolled into a plug and then pushed into the neck. Any loose bits inside can be compacted gently by using a probe inserted through the hole broken in the bottom. This is the finished device ready to be charged. To charge The Machine, enough for one or more good doses (the more the better) is directly applied to the surface of the steel wool at the mouth of the bottle. The neck of the bottle is then gently heated just enough to cause the alkaloid to melt into the steel wool plug. If not intended for immediate use or if intermittent use is desired the cap can be replaced over the charge to protect it. Freshly applied DMT resin can be prevented from contacting the cap by placing a small piece of paper between it and the cap (rolling paper works well for this). The Machine can also be charged for multiple users by placing a much larger quantity on the inside of the plug by dropping it through the broken hole. Charging is done the same way, by gently heating the neck until the plug absorbs the alkaloid. To use The Machine, simply point the neck downwards and heat the steel wool plug from below with a lighter, while slowly inhaling through the hole made in the bottom. (Take care not to overheat and ignite the steel wool.) Rotating the bottle while heating will help it volatilize evenly. The high surface area and heat distribution of the steel wool traps the liquid alkaloid, both retaining it and driving it into vapor. This trapping effect also permits the pipe to be simply set down, then picked up and reheated, as needed. There is little to no loss with The Machine and for some unknown reason we have reliably found this pipe to be smoother on the lungs than many far less efficient devices—particularly the glass “crack” pipes. The amount of alkaloid that this device is capable of delivering must be experienced to be believed. The bottle can be reused but the steel wool should be replaced regularly. While The Machine works with many materials, extracted Acacia alkaloid is highly recommended. — Justin Case
I sandwich the DMT in a bubbler between a lower and upper layer of Damiana. The lower level is to prevent the DMT from falling through and the upper level is to have a cushion for the flame so I'm less likely to burn it. I can't say that it's automatic breaking through everytime if I hang around that 50-60 mgs range but it happens often. Some of the reading I've done suggest that DMT can be kind of fickle sometimes when you reside around that the lower ends of the breakthrough dose range. I've only tried to go significantly higher once and I found I was close to blacking out and remembered very little of the trip.
If the anal bum cover method doesn't work, I might think about putting some extracted DMT on top of some weed in a vapor genie.
Troll: you put it in your penis. Philosopher: You don't ingest IT, IT ingests you. Real world: What GB said.
Anyone have experience using a volcano vaporizer? the one that uses the big bag for vaping weed. I assumed it wouldnt work but my friend said he looked into it and read that it works great supposedly
Use a vape (meth) pipe, that is the only way imo. Best way to get te best experience with what you're working with. I personally love the taste of dmt and it smells like lilacs.
The best way is to buy a freebase pipe for around 9$ at a smoke shop, they will think you are going to smoke meth when you buy it, but make sure they know it's for tobacco usage ;D
