Homemade grinder

i've been looking all over my town for a grinder but there's like nowhere tht sells them, anyone have an idea to make one? was thinkin about taking some old coasters (like for setting drinks on) and puttin nails throught themwhich seems pretty easy, but i am dredding tryin to fit it so that it can work without the nails hitting eachother and keeping it from spinning

 

uh... where do u live? if there is a headshop that doesnt sell grinders, then... its not a headshop... look on the internet as well

 

nails most certainly will not work. you need something sharp that will actually "shred" the weed

 

Nails definitely are sharp. My grinder just has pins, but they are close enough together that when it turns, the weed is ripped apart. Pyramids work better than pins, theoretically the nails would work. Assuming you measured where they would hit. Close, but not too close.

 

Break it up with your fingers.

 

Nails are only sharp on the point. They need to be sharp on the sides, because that is the part that would be grinding the bud.

 

use ur fingers

 

I think it's kinda fun to use my fingers to break up good bud. But breaking up shitty/stringy bud is another story.

 

my friends sweetleaf grinder only has pins that are not sharp, they are round and it works just as good as my grinder that has sharp prongs. Nails will work jsut make sure ther very small.

 

coffee grinder??? maybe

 

just put the bud in one of those orange pill bottles and chop it up with scissors

 

im gona throw one in ceramics. its jst i need a way to get the nails in. and as far as spacon do the bottom in lines 1cm apart and space the nails4mm apart, and when u do the other side place em 1cm apart and just a bit closer together and it should line up perfectly

 

10$ electric coffe grinder, I use it for all my psychoactive plants...

 

i just use my superpowers to do it