Ok so recently my wife gave me a nice treat by sucking me to completion. She doesn't do this very often since it takes so long for me to get off that way. (1 hour or more.) So it is a nice little treat when I get that. Anyways this particular time, she started to play with my butt hole a little. I have expressed interest in this in the past, so she knew that I would be into it. To help things out, I then reached for one of her more powerful vibrators, and just held it right on the rim while she finished up. I shortly thereafter had the absolute most mind numbing orgasm I have ever had. Since that time, I have been looking for ways to explore that a lot more. What currently has piqued my interest is this idea of a prostate massage tool such as the Aneros Helix. In a rush to try this thing out, I went to a local novelty shop to look for this device. Unfortunately, they did not have what I was looking for, but they did have this little number which looks to be very similar: http://www.amazon.com/Nasswalk-Fantasy-Deluxe-Perfect-Silicone/dp/B00FQ6AMWO. I grabbed it, and started my prep work. I took a shower, making sure everything was clean. I then laid on my side and began to apply appropriate lubrication. Getting a finger in there was no problem at all, and after a good bit of time relaxing and "warming" things up, I lubed the device and began trying to insert it. At only 1.25" in width, I did not see where this should be much of an issue, but it was. I kept trying for more than an hour, taking small breaks in between each attempt, reapplying lube, retrying the finger treatment, massaging the area, etc, etc. Basically I did everything that I have read on every site I could find that is dedicated to using these devices. I still could not get this thing to go any further than about half of the tip. I finally gave up on it last night, and decided to try again this evening. In my efforts, things seemed to meet a physical resistance, but my finger and a slightly smaller, straight sided device slid right in with no issues. So I am thinking that my insertion angle is not right. If anyone here has experience with this or a similar device, can you help me figure out if there is a trick to getting this thing to go in? Are there any good instructional videos or illustrations that will help?
