help me with this question...

Discussion in 'LSD - Acid Trips' started by Intense.Reaction, May 1, 2007.

  1. How would i go about dessolving a drug and adding it to blotting paper? do i use alcohol? or water? how do i know the absorbtion rate?

    Any information anyone can provide would be helpful...
     
  2. what kind of drug?
     
  3. say its 2c-b or foxy for instance. Doc... maybe... not sure yet... just easier to dose out for when we do our research =)
     
  4. Glordag

    Glordag Member

    When you say dissolving do you mean diluting? I would definitely say it's a bit trickier than just adding water, and I would especially say adding alcohol is a bad idea. I'm sure it's possible water could work, but I definitely think this would be dependent on the drug. Also, not every drug will lend itself to being put on blotter. I would do some research over on erowid if you can find any articles on it. Otherwise, just google it up and hope for some results. Good luck!
     
  5. PsychMyke

    PsychMyke Senior Member

    2cb isnt active at low enough doses for blotter paper
     

Share This Page


  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice