Homemade DMT

Discussion in 'DMT' started by ancient powers, Feb 16, 2007.

  1. ancient powers

    ancient powers Member

    Messages:
    873
    Likes Received:
    3
    How to easily make DMT:
    =======================
    Break 1-Pound of Mimosa Hostilis rootbark into 2" pieces and grind it all up in a glass-topped blender, a little at a time.
    ------------------------------------
    Polar Extraction: Premix in an empty 1-Gallon plastic jug: 1-Quart White Vinegar & 3-Quarts Water. Put the ground up Mimosa in a 3-Liter crockpot, then fill it with the water-vinegar solution. Stir well and turn it on "high". After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off most of the liquid into a 1-gallon wide-mouthed glass or stainless container. Add the remaining water-vinegar solution to the crockpot again. Stir well and turn it on "high". After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off all of the liquid into the same container again. Discard the rootbark fiber and save the two combined extractions in the 1-gallon container. Allow the vegetable particles in the extraction in the 1-gallon container to settle to the bottom overnight. Then pour off the liquid into an empty 1-Gallon glass wine jug, being careful not to pour off any of the vegetable sludge at the bottom. Discard the sludge and keep the contents of the wine jug.
    ------------------------------------
    Basification: Premix in advance a solution of: 5 Tablespoons (63grams) of Sodium Hydroxide ("Red Devil" lye) with 1-Pint of WARM Water. Stir well. Slowly add this solution to the wine jug, then cap the jug. Gently tilt the wine jug back and forth for 1 full minute to mix the contents.
    ------------------------------------
    Nonpolar Extraction: Add 250ml of (Ace Hardware)VM&P Naptha to the wine jug. Add exactly enough warm water to the jug to raise the liquid level to an inch below the top, then cap the jug. Gently tilt the wine jug slowly back and forth for 5 full minutes to mix the contents. Allow the jug to sit undisturbed on a table for at least 4 hours. There should now be two layers visible in the jug, a lower dark one and a smaller clear one on top filling the neck of the jug. Use a glass turkey baster to suck up the top clear layer into a pint mason jar. Be careful not to suck up any of the lower brown/black layer into the mason jar.
    -------------------------------------
    Freeze-precipitation/wash: place the sealed mason jar in a FREEZER for 3 days to precipitate the crystals. Prepare a filter setup by placing a funnel into a quart mason jar and putting a small coffee filter paper into the funnel. Shake the naptha in the mason jar strongly to stir up all the crystals at the bottom and quickly pour while still very cold into the funnel for filtering. Impure yellow-white DMT crystals will be seen on the coffee filter paper. Allow the crystals to completely dry out on the filter paper in the funnel. Premix a wash solution by mixing equal parts of Distilled Water and NON-SOAPY clear Ammonium Hydroxide(Ace Hardware Janitorial Strength Ammonia) into a pint container. Slowly pour 100ml of the wash solution over the crystals (still in the filter paper) to wash them. Remove the filter paper from the funnel, spread it out flat and allow the crystals to COMPLETELY dry out. You will now have 2-1/2 grams of white crystal DMT. At least 50 strong doses. Mix it with some parsley and smoke a little in your favorite pipe!
     
  2. INSANEPOOKIE

    INSANEPOOKIE Prancing Dragon

    Messages:
    248
    Likes Received:
    0
    In regards to the lye: You must ensure there's nothing else in the Sodium Hydroxide.
    Here in Oregon they no longer sell drain cleaner that is only Sodium Hydroxide. They mix it with Alum.


    Example:
    [​IMG]

    If you look up the MSDS:
    [​IMG]

    The VM&P Naptha here are clear of any scary adulterants.
    One should do a VERY simple test with Naptha just to be safe.
    Pour a ounce or two of the Naptha into a clean jar and let it evaporate. There should be no spell or left over residue afterward. If there is, don't use it.

    Do not breath in the fumes from Naptha.

    One can find the MSDS for just about everything by entering in the company, product and MSDS in google.
     
  3. SILVERWOLF_87

    SILVERWOLF_87 Member

    Messages:
    446
    Likes Received:
    0
    Are there any chemicals in this recipe that are carcinogenic or otherwise harmful?
     
  4. kidsmoke

    kidsmoke Member

    Messages:
    559
    Likes Received:
    0
    NaOH is something to take care with. You can get pure stuff for making soaps if your state doesn't sell the right drain cleaner. It also makes really good soap. Naptha is highly combustable, and as pookie said, don't breath the fumes. Other than that the only potentially harmful chemical is the product itself. Be careful with the D too!
     
  5. SILVERWOLF_87

    SILVERWOLF_87 Member

    Messages:
    446
    Likes Received:
    0
    Is there anyway to get the entire balanced chemical equation for this extraction process? I'd be interested in seeing how the equation works out.
     
  6. kidsmoke

    kidsmoke Member

    Messages:
    559
    Likes Received:
    0
    The equation wouldn't be much, seeing how there are not any real reactions to get the product. It's already there of course, you're just taking it out and forming a salt. A synthesis would be a different story.
     
  7. SILVERWOLF_87

    SILVERWOLF_87 Member

    Messages:
    446
    Likes Received:
    0
    Ahh, so it's more of a physical change than a chemical change... Alright, thanks for the info :D
     
  8. falsereality

    falsereality Member

    Messages:
    189
    Likes Received:
    0
    how would smoking just the bark (other than the smoke obviously being harsh) compare to DMT
     
  9. SILVERWOLF_87

    SILVERWOLF_87 Member

    Messages:
    446
    Likes Received:
    0
    Well, if it takes 1 pound of bark to yield 2 grams of DMT, you're looking at bark that contains about 0.4% DMT, which is not much...

    Granted, it also doesn't take much DMT to send you off to another land...

    Give it a shot sometime, and see what happens :D
     
  10. falsereality

    falsereality Member

    Messages:
    189
    Likes Received:
    0
    so wuts moderate dose of DMT?
     
  11. SILVERWOLF_87

    SILVERWOLF_87 Member

    Messages:
    446
    Likes Received:
    0
    Taken from Erowid:

    Smoked DMT Dosages
    Threshold 2 - 5 mg
    Light 10 - 20 mg
    Common 20 - 40 mg
    Strong 40 - 60 mg

    Onset : 15 - 60 seconds
    Duration : 5 - 20 minutes
    Normal After Effects : 15 - 60 minutes

    I don't see why it wouldn't be possible to get some effects from a gram of smoked bark... Granted, smoking a gram of anything is a lot, but you wouldn't have to go through the long and potentially dangerous extraction process.

    Don't take my word for it though, I've never tried smoking mimosa bark before :D
     
  12. falsereality

    falsereality Member

    Messages:
    189
    Likes Received:
    0
    wouldnt it be better to post an example that we WANT? lol
     
  13. Putty

    Putty Member

    Messages:
    41
    Likes Received:
    0
    here's some pure lye..
    http://www.bestdeal.org/Merchant2/merchant.mvc?Screen=CTGY&Store_Code=Essential&Affiliate=lyedepot&Category_Code=277a

    BTW...t's probably more realistic to expect .5 g from a pound of Mimosa. Perfect technique could yield 1 g...and smoking the MHRB doesn't work...

    I've heard from others that it is definitely worth the hassle of extracting, even if you do it only once to experience this chemical DMT that occurs natuarally in all of us if smoking 2 or 3 hits of 25 mg will show you a new world.
     
  14. mask_of_insanity

    mask_of_insanity Member

    Messages:
    180
    Likes Received:
    0
    what is the street price of dmt i know its almost never seen but when it is how much is it
     
  15. stvt32

    stvt32 Member

    Messages:
    49
    Likes Received:
    0
    This may be a stupid question but... using only a half pound of the bark you can just do everything half and it will come out with about 1 gram right? I know that's how it should work, but I dunno, there might be some crazy anomolie that might mess with it.
     
  16. Putty

    Putty Member

    Messages:
    41
    Likes Received:
    0
    it all equals out...just don't count on getting that much yield. The high yields will come with practice and also different samples of raw material will have varying levels of DMT content
     
  17. mask_of_insanity

    mask_of_insanity Member

    Messages:
    180
    Likes Received:
    0
    no one knows
     
  18. Putty

    Putty Member

    Messages:
    41
    Likes Received:
    0
    it was spotted on one of those europa websites that sells illegal mj bud through the mail..it was listed way down a long list of items and small print which read "crystal dmt" 150.00 g

    other then that I've never heard of it for sale
     
  19. mask_of_insanity

    mask_of_insanity Member

    Messages:
    180
    Likes Received:
    0
    how much was it
     
  20. Putty

    Putty Member

    Messages:
    41
    Likes Received:
    0
    150 US
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice