How Do you BreakDown MS COTIN (MORPHINE?)
Posted November 15 2005 - 09:09 PM
any help would be apprecieated
oh yeah, if you wanna bitch about shooting up then get the fuck outta the Opiate forums. :O)
Posted November 23 2005 - 09:23 PM
Posted November 25 2005 - 07:16 PM
try using ice water with a drop or two of lemon juice
if you have enough, try water with baking soda. After a few mins, discard the water and keep the goo.
Then try breaking it down with water with a little white vinegar in it.
no promises- good luck!
Posted November 26 2005 - 06:16 AM
Im pretty sure that Ms contin is indeed a brand name of morphine. ive never heard of hydromorphone going under that name. maybe its just me though
Posted April 28 2006 - 07:44 AM
doesn't the MS stand for Morphine Sulfate ?
yep^ hydromorphone is generic dilaudid-different than mc-contin!
Posted May 16 2006 - 11:33 AM
For the record:ms is hydromorphone, not morphine.
thats just not true. Hydromorphone is marketed under the brand name Dilaudid. MS contin is Morphine Sulphate, if you want to check go to http://www.erowid.org/pharms/morphine/ it says MS contin in the common and brand names box. i'm guessing y'all are talkin about those little pills that look like oxy's but have a blue coating and say M on one side, 100 on the other (at least the 100 mg pills). yeah, and they have a gelling agent inside which is why their also a bitch to snort - they gel up in your nose and are very hard to sniff all the way back, ends up getting stuck up there and tastes like shit! one of the worst drips besides molly.
Posted May 16 2006 - 04:35 PM
MSContin is seperated from Dilaudid by their most common brother, heroin (diacetyl morphine). I prefer MS over any other compound, as it's easy to ingest, and easy to obtain.
And, no, MS is NOT hydromorphone...it is Morphine Sulphate; NOT morphine. Get your shit straight, retard. :rolleyes:
Posted May 16 2006 - 04:52 PM
Posted February 29 2008 - 06:47 AM
ATTENTION ALL WHO ARE NEW AT THIS PROCESS! -YOU DON'T NEED TO COOK YOUR PILLS AFTER CRUSHING THEM!! FORGET THE HOLLYWOOD BULLSHIT. lab prepared pills contain waxes that cause absises in your ateries and amputaion may most likly results over time and even death!! and for fucks sake don't cook'em, they are prepared in a lab and contain various chalks waxes and other shit specially designed for gentle ingestion in the gut they are not designed to be in injectied (even though its easy to do!) AND BY THE WAY DON'T SUCK ON EM TO CLEAN EM, USE A ALCOHOL SWAB FOR CHRISTS SAKE! SALIVA HAS ACIDS TO BREAK DOWN CHEMICALS AND TURNS EM TO MUCH IN PREPARATION FOR INGESTION, SUCKING ON THEM FUCK THEIR COMPISITION AND MAKES THEM MUCK.
ok here we go:
1. USE AN ALCOHOL SWAB TO CLEAN THE PILL AND GENTLY DRY WITH THIN COTTEN TOWEL (like a pillow slip)
2. place the dry pill in some folded paper and gently crush with the back of a tablespoon until the pill is well broken down
3. carefully pour the powder into a shot glass and add 8ml of clean water.
4. stir the mix with the plastic tip of the needle cover or the top of the plunger (the flat part) don't over stir put gently make sure the powder is broken up and fine.
5. LET THE MIXTURE (SOLUTION) SIT FOR ABOUT 5-10 MIN this allowes the chalky shit to sink to the bottom, the morphine is soluble and dissolves.
6. attach the filter to the barrel (plunger) it screws on, and add the pick (needle tip) to the other side of the filter
7. place a bit of a cig filter or cotton wool in the solution and gently draw the solution up through the filter, you should get a nice clean product looking like clear water without any shit apart from a few bubbles and make sure you get rid of these air bubbles (as you should already know). also be sure not to let the tip get to close to the chalk as its a pain in the arse to have to clean the tip half way throu the draw back.
8. take the filter off, you can re-use it once more, (but make sure its used the same direction as before otherwise oall the shit will go into your syring and solution) put your tip back on and away you go.
Ps you can keep the chalk and reuse for a later hit. it won't be as strong but it stil has morph in it. there you have it, the whole process takes about 15min if that!, not heating, its clean and very safe.
hope it helps.
Posted February 29 2008 - 12:20 PM
this is a question if anyone knows how to succesfully breakdown a MSCotin
Strap it in a hard chair and shine a bright light in its face while playing Barry Manilow music over and over.
Posted February 29 2008 - 12:26 PM
Every hour wounds. The last one kills.
Posted February 29 2008 - 12:45 PM
Some more lint? lol.
Posted February 29 2008 - 03:57 PM
Either you're too ignorant to read up on the shit the doctor fills your body with, or you're just REALLY bad at lying.
I've got a pescription!
* Twizz is NOT a medical professional, and none of the information that he provides has been directly confirmed by a registered doctor. Should you have any serious concerns, please contact a licenced physician and don't ask a bunch of random people in a forum. *